Icarus

200,000 ft attempt

With Icarus, we’re working toward a 200,000 ft altitude attempt.

Filament-wound airframe component on the X-winder. — These photos show our filament-wound airframe components on the X-winder, during curing, and after surface finishing.

Composite airframe components during cure. — These photos show our filament-wound airframe components on the X-winder, during curing, and after surface finishing.

Motor mounted on an outdoor test stand. — Here’s our phenolic nozzle hardware, machined in house, alongside the full N2915 motor test firing with an expansion cone.

Machined phenolic nozzle hardware and metal component on a workbench. — Here’s our phenolic nozzle hardware, machined in house, alongside the full N2915 motor test firing with an expansion cone.

Full rocket standing upright in a workshop. — I’ll share an after-action report following the September 2026 launch.